Filter
Top Products
22
2. Press the [1W/5WLOCK] key to
change the transmitter output to 1
watt.
3. Press the [1W/5WLOCK] key again to
change back to 5 watts.
Note: Each time the [1W/5WLOCK] key is
pressed a short tone sounds.
Certain channels are preset as 1
watt channels. They are: 13 and 67
for the USA channels, and 13, 15,
17, and 20 for the CAN channels.
When the Channel is set as a low
power Channel, you can temporarily
transmit at 5 watts by pressing and
holding the [1W/5WLOCK] key while you press the PTT button.
Entering Channel Numbers into Memory Scan
You can enter channels into Memory Scan for instant scanning at any
time. When a Channel is selected for Memory Scan,
MEM appears on the
LCD display. To enter a Channel into Memory Scan, select the Channel
you want to store by pressing S or T, and then press and hold [SCAN/
MEMORY] for 2 seconds. The Channel is stored in Memory Scan and
MEM appears on the LCD display.
To cancel the Channel in Memory, press and hold [SCAN/MEMORY] for 2
seconds and the
MEM icon disappears.
Mystic OM.book Page 22 Wednesday, October 22, 2003 8:59 PM