Filter
Top Products
124
If the MYSTIC does not perform to your expectations, try the suggestions
listed below. If you cannot get satisfactory results, call the Uniden
Technical Support at (800) 586-0409, 8:00 a.m. to 5:00 p.m., Central
Standard Time, Monday through Friday.
Symptom Cause Remedy
Won’t power On. No or low voltage. Check for proper
voltage getting to the
radio.
When the PTT button is
pressed, the TX icon
appears and another
radio can hear a “click”
but no audio is heard.
Bad microphone
element.
Send the radio in for
repair.
While scanning, the
radio stops on a
particular Channel all
the time.
A source of noise may
nearby.
Eliminate the source of
the noise or delete the
Channel from the scan
memory.
There is noise on the
receiver that the
squelch will not
eliminate.
An external noise is
being generated by
some device nearby.
Either turn off the
offending device or
contact the
manufacturer regarding
FCC part 15
“unintentional radiation”.
Troubleshooting
Mystic OM.book Page 124 Wednesday, October 22, 2003 8:59 PM