Filter
Top Products
3-6 Lassen-SK8 Embedded GPS Module
Software Interface
Configuring the ACE GPS receiver output protocol from TAIP to TSIP
protocol TAIP message PR
Configuring the receiver output from TAIP to TSIP will display binary data in now
displayed on the screen.
1. Run GPSSK /x. Press [x] to select the Host Computer COM Port
2. When the GPS Main screen appears, press [ENTER]
3. Type the following message to set the receiver to TSIP.
>SPR;TAIP=FF;TSIP=TF;<
Where:
4. Press [ENTER] to complete the change
Use TSIPCHAT to make additional changes.
3.4.3 NMEA 0183 Data Output
The National Marine Electronics Association (NMEA) protocol is an industry standard
data protocol which was developed for the marine industry. Trimble has chosen to adhere
stringently to the NMEA 0183 data specification as published by the NMEA. Although
the Trimble Lassen-SK8 supports seven NMEA sentences that contain GPS information,
the standard Lassen-SK8 only outputs the GGA and VTG data strings.
*
Note – Contact your Trimble sales representative if you need access to all or a subset of
the other five NMEA sentences.
Table 3-2. TSIP Message Description
ELEMENT DESCRIPTION
> Beginning of command sentence
S The Set Command
PR The TAIP protocol message
TSIP The desired protocol
FF Port 1 off
Port 2 off
TF Port 1 in /out
Port 2 off
I/O Port 1 in
Port 2 output
< End of command sentence