Filter
Top Products
997-01530-01, Rev. C-25, Jan 2008 75
2
5
1
SSSSSSSSSSSS SSSS SSSSSS SSSSSSS S SSS SSSSSSS
The following table gives the command line equivalents for each of the preceding parameters:
Group 2
The following expanded command set is available through the command line interface:
You can reconfigure two or more network parameters in a single entry by sending the F100 command
and entering new values. Leading zeros may be omitted when entering IP Address, Subnet Mask, and
Default Gateway. Any field may be omitted and order is not significant. Blanks are allowed on either side
of a colon. The unit reboots after any network parameter is changed.
Description “F100” followed by: Comments
Ethernet address
(MAC address)
EA Displays information
IP Address IP Displays, configures and reboots
Subnet Mask SM Displays, configures and reboots
Default Gateway G Displays, configures and reboots
IP Address, Subnet Mask,
and Default Gateway
IC Displays several IP parameters
10 100 BASE-T BASET Displays network port setting
Remote Lockout L (for status), LOCK, UNLOCK Displays and configures
Flash CRC ST Displays information
RAM ST Displays information
Serial ST Displays information
Version Test
(NVRAM Ver)
ST Displays information
Description
“F100” followed by: Comments
Burn Host BH Configure
Burn BU Commit action
Burn Bootloader BUB Commit action
Burn Filesystem BF Commit action
Configure NTP & SNMP Parameters CONFIG Move files
Factory Mode Jumper J Display only
Reboot K I L L Commit action – reboot the XL-
GPS
Change User Password P Configure
Ping PI Commit action
Change User Name PN Commit action