Filter
Top Products
997-01530-01, Rev. C-25, Jan 2008 55
2
5
1
SSSSSSSSSSSS SSSS SSSSSS SSSSSSS S SSS SSSSSSS
F53 – GPS Operation Mode
Use function F53 to set the GPS M12 Receiver in Time Mode or Dynamic Mode.
Select “Dynamic Mode” if the position of the receiver is subject to frequent change, or if it is in
continuous motion. For example, use Dynamic Mode when the XL-GPS is used in mobile vehicles such
as ships, land vehicles, or aircraft. With Dynamic Mode selected, the receiver updates the position
information repeatedly to arrive at the best time calculations for a mobile environment.
Select “Time Mode” if the receiver used in a static environment such as a server room. With Time Mode,
the receiver averages the position data over time to determine the antenna position and calculate the
time precisely and accurately.
Keypad
While viewing the Status screen on the XL-GPS front panel display, press the following keypad buttons:
ENTER 53 ENTER
If a GPS M12 Receiver is not available, F53 displays:
GPS M12 AVAILABILITY
NOT AVAILABLE
Note: If F53 indicates that M12 is not available, reset M12. If availability is still an issue, call customer
service.
If a GPS M12 Receiver is available, F53 displays:
GPS MODE SELECT
TIME MODE (or DYNAMIC MODE)
To change the mode, use the UP/DOWN ARROW buttons and press ENTER. F53 asks:
SAVE CHANGES?
YES
To save changes, press ENTER.
Command Line
To request the GPS operation mode of an GPS M12 Receiver (87-8028-2), enter:
F53<CR>
F53 responds using the following format:
F53<SP><SEP><STATUS><CR><LF>