Filter
Top Products
74 997-01530-01, Rev. C-25, Jan 2008
SSSSSSSSSSSS SSSS SSSSSS SSSSSSS S SSS SSSSSSS
1
F100 – Network Port Configuration & XL-GPS Firmware
F100 provides two groups of commands:
• Group 1, available through the keypad and the command line, provides access to network port
settings and hardware/Firmware status information.
• Group 2, available through the command line only, provides commands for changing system
firmware, changing NTP & SNMP parameters, changing the user name/password, resetting the
unit, and pinging other network devices.
Warning: The F100 commands have the capacity to remove the XL-GPS from the network and disable
the XL-GPS’s system firmware. Use judiciously.
Reboot Warning: Saving changes to any F100 parameter
using the keypad will reboot the XL-GPS.
Some of the F100 command line commands also reboot the XL-GPS. These are identified in the
following documentation.
Group 1
You can use both the keypad and the command line interface to access the following parameters:
• Ethernet address: XL-GPS contains a unique Ethernet or Media Access Control (MAC) address
comprised of a unique number assigned to the manufacturer, and a unique number assigned to
the unit. This is factory set and cannot be changed.
• IP Address: Sets a static Internet Protocol (IP) address for the unit.
• Subnet Mask: Sets a valid subnet-mask used in IP addressing. Subnetting allows for the more
efficient allocation of network addresses and management of network traffic.
• Default Gateway: The address of the router that handles packets addressed to IP devices outside
the local-area network.
• 10 100 BASE-T: View network port setting: 10 or AUTO.
• Remote Lockout: Enables or disables remote access through the XL-GPS’s standard network
port. Enabling Remote Lockout limits users to the front-panel keypad or Serial I/O port.
• Flash CRC: Status - Passed or failed.
• RAM: Status - Passed or failed.
• Serial: Status - Passed or failed.
• Version Test: Status - Passed or failed