Filter
Top Products
997-01530-01, Rev. C-25, Jan 2008 33
2
5
1
SSSSSSSSSSSS SSSS SSSSSS SSSSSSS S SSS SSSSSSS
F71 – Oscillator Statistics
K, N, S Display the XL-GPS oscillator’s phase, offset, drift, and
DAC values
F72 – Fault Status
K, N, S View clock and power supply fault status
F73 – Alarm Control / Status
K, N, S View the status of all the alarm indicators. Enable/disable
alarms for each indicator. Set alarm thresholds. Enable or
disable LED blink
F90 – Code Output Configuration
K, N, S Configure settings for CODE – time code output
F100 – Network Port Configuration &
XL-GPS Firmware
K, N, S Configure the standard network port settings
F100 EA – Ethernet Address
K, N, S Display the Ethernet (MAC) address
F100 IP – IP Address
K, N, S Configure the IP address
F100 SM – Subnet Mask
K, N, S Configure the subnet mask
F100 G – Gateway
K, N, S Configure the default gateway
F100 IC – Network Port Settings
K, N, S Display all the standard network port’s settings
F100 L/LOCK/UNLOCK – Remote
Lockout
K, N, S Lock remote access to the XL-GPS’s standard network
port
F100 L – Remote Lockout Status
K, N*, S Display the status of F100 LOCK
*Locked through the network port, serial port, and
keypad. Can be unlocked only through the keypad or
serial port.
F100 ST – Self Test Status
K, N, S Display the XL-GPS’s self test results for Flash CRC,
RAM, Serial Port, and NVRAM
F100 BH – Burn Host
N, S Upgrading system firmware: select the FTP host, path,
and filename of the system firmware
F100 BUB – Burn BootLoader
N, S Upgrading system firmware: ‘burn’ the bootloader file
(*.bt) selected using F100 BH to flash memory
F100 BU – Burn
N, S Upgrading system firmware: ‘burn’ the system firmware
file (*.bin) selected using F100 BH to flash memory
F100 BF – Burn File System
N, S Upgrading system firmware: ‘burn’ the file system file
(*.fs) selected using F100 BH to flash memory
F100 BUFP – Burn FPGA Firmware
N, S Upgrading system firmware: burn the FPGA program file
(*.bin) selected using F100 BH to the flash memory
F100 CONFIG – Configure NTP &
SNMP
N, S Transfer the NTP and SNMP configuration files between
the XL-GPS and an FTP server for editing
F100 J – Factory Mode Jumper
N, S View the status of the factory mode jumper, which is used
by factory technicians. Not of interest to most end users.
F100 K I L L – Reboot
N, S Reboot the XL-GPS
F100 P – Change User Password
N, S Change the XL-GPS password
F100 PI – PING
N, S Ping from the XL-GPS to another host on the network
F100 PN – Change User Name
N, S Change the User Name