Filter
Top Products
8
ENGLISHFRANÇAISEESPAÑOL
4. Pull the starter handle slowly until resistance is felt. This is the “compression” point.
Return the handle to its original position and pull swiftly. Do not pull the rope out all
the way. After starting the engine, allow the starter handle to return to its original
position while still holding the handle.
• After starting the engine, gradually slide the Choke Lever fully toward the fuel tank
(RUN position). The colder the ambient temperature, the more time the engine may
require to run with the Choke Lever in the START position before moving to the
RUN position.
Running the Engine
1. After starting, slide the Choke Lever fully toward the fuel tank (RUN position). Let
the engine warm up without using the machine (no load) for a couple of minutes.
The engine speed is adjusted at the factory to operate a specifi ed speed. Do not
attempt to alter the speed as it may cause damage to the engine.
Stopping the Engine
1. Remove the load (stop operation) before turning the engine OFF.
2. Turn the engine stop switch to “OFF” (“O” position) to stop the engine.
3. Close the fuel valve (if equipped).
Stop Switch
Fuel Valve
CLOSE
CLOSE
OPEN
ON
OFF