Pioneer AVIC-8DVD GPS Receiver User Manual


 
91
Chapter 7
Operating Your Navigation System with Voice
Chapter 7
Operating Your Navigation System with Voice
Basics of Voice Operation
Your Pioneer Navigation System comes with the latest in voice recognition technology. You can
use voice commands to operate many of its functions. This chapter describes where you can use
voice commands, and also what commands the system accepts.
Flow of voice operation
You can start voice operation any time when the screen under route guidance or a map is dis-
played (even when the map is scrolling).
The basic steps of voice operation are as follows. The steps are almost the same as when
using the Remote Controller.
With the “CD-SR80” Steering Remote Controller (sold separately), you can press the BAND
button and the F button to switch on the operation mode of the Steering Remote Controller.
When the operation mode is switched on, by pressing the BAND button of the Steering
Remote Controller, you can activate voice operation, which is equivalent of pressing the
TALK button.
When your Navigation System starts, you can also enter the password using your voice.
1. Press the TALK button to activate voice operation.
2. Speak a command into the microphone.
3. When the command is recognised, it is repeated.
4. As necessary, repeat Steps 2 and 3.
5. The voice command is carried out.