Pioneer AVIC-8DVD GPS Receiver User Manual


 
21
Chapter 1
Getting Started
Do not try to use discs other than a disc designed for this system. Please use only the disc
specified by Pioneer.
Do not attempt to use discs that is cracked, scratched, bent, or otherwise damaged.
Treat your disc carefully. See Handling and Care of the Disc on page 101 for advice on
proper handling and use.
After removing the disc from the slot, keep it in the case.
Setting the PC card
Open the cover at the front of the main unit. Hold the PC card label-side up: the arrow shows
the direction of insertion. Insert the card firmly until the PC card ejection button pops out. If
the main unit power is on, the PC card lock lamp changes from green to red, showing that the
PC card is inserted correctly and ready for use.
Removing the PC Card
Open the cover on the front of the main unit. Slide the PC card lock lever to the right (1), and
hold it there. Check that the PC card lock lamp has changed to green, and then press the PC
card ejection button (2). (Keep sliding the PC card lock lever to the right until the PC card is
removed completely.)
Caution
Do not remove the PC card while the PC card lock lamp is red. It may break the
main unit of the Navigation System or the PC card.
PC card can be set or removed regardless of the power ON/OFF of the main unit (ON/OFF
of the engine).
You can only use a card that conforms to the PCMCIA Type II (5V) standard. If you attempt
to use a card complying with a different standard, the card slot may be damaged, or a mal-
function may occur.
Do not remove the card while editing the data on the PC card. You may break the main unit
of the navigation system, or corrupt the data stored on the PC card.
1
2
3