Pioneer AVIC-8DVD GPS Receiver User Manual


 
83
Chapter 5
Utilising Various Information
2 Push the BACK button.
The previous screen appears.
Checking the connections of leads and installation positions
Check that cables are properly connected between the main unit and the vehicle. Please also
check whether they are connected in the correct positions.
1 Select Information in the Main menu, then select Location Status and Connec-
tion Status. Click the OK button.
The Connection Status screen appears. Either “OK” or “No good” appears on the screen,
and connection status of each cable is shown.
1.Speed Pulse
The number of the Speed Pulse detected by this unit is shown. “0” is shown while the
vehicle is stationary.
2.GPS Aerial
The connection status of GPS antenna and the sensitivity are shown. If “No good” is
displayed, check the connection status of GPS antenna.
3.Installation Position
The Installation position of the main unit is shown. If “No good” is displayed, refer to
“Installation Manual” for the installation position.
4.Handbrake
When the parking brake is applied, “On” is displayed. When the parking brake is
released, “Off” is displayed. Keep the foot brake on while checking that the parking
brake connection works properly.
5.Voltage
The power supply (reference value) provided from the vehicle battery to this unit is
shown. If the voltage does not fall within the range of 11 to 15V, check that power
cable connection is correct.
6.Illumination
When the lamps of a vehicle illuminate, “On” is displayed. When the lamps of a vehi-
cle go out, “Off” is displayed. (If the orange/white lead is not connected, “Off”
appears. )
To clear the memory...
If you want to delete the memorised learning contents of “Distance”, “Speed Pulse
Counter”, or “Learning Status”, perform the following procedure:
1 Select the item you want to delete, and click the OK button.
2 While Clear is highlighted, click the OK button.
2
3
5
6
7
4
1