Filter
Top Products
F8QT ENGINE -
Flywheel
11A-22-2
INSPECTION
FLYWHEEL
Axial throw
(1) If the axial throw exceeds t h e limit value, check t he
flywheel for a loose bolt
1
or for a defective connection
to the crankshaft. Repair or replace as necessary.
Deformation of the friction surface
(1) If necessary, replace the flywheel
3
.
NOTE
A new flywheel is always supplied complete with th e ring
gear.
INSTALLATION SERVICE POINTS
"
A
A
FLYWHEEL RING GEAR INSTALLATION
(1) Heat the flywheel ring gear
2
with an oxyacetylene torch,
or a similar device for applying heat locally, to
approximately 22 0 _C.
(2) Fit the flywheel ring gear
2
on the flywheel
3
, with the
chamfered side facing towards the flywheel.
A
: Chamfered side of flywheel ring gear.
"
B
A
FLYWHEEL INSTALLATION
(1) Remove all traces of sealant, oil and other substances.
Caution
The flywheel can be fitted in one way only. This is
because the bolt hole pattern is asymmetrical.
(2) Coat the mating face of the flywheel to the crankshaft
with a locking agent (Part No. 1161059-1).
(3) Use new bolts and coat the screw threads with liquid
gasket cement (Part No. 277917-1).
(4) Use flywheel stopper MB996015 an d tighten the bolts
53 Nm.
PWEE9602
E
July 1996Mitsubishi Motors Corporation
REN0122
4ME0270
3
REN0123
A
REN0147
MB996015