Filter
Top Products
F8QT ENGINE -
Fuel Injection Pump
11A-19-5
(5) Turn the crankshaft (clockwise) 1 3/4 revolutions.
(6) Remove the plug
A
.
(7) Fit measuring device adaptor MB996030.
D Locate the guide bush
B
in the pump.
D Slide the measuring pin
C
, which is part of the
measuring tool, into the guideway of th e pump.
D Locate an d secure the holder
D
.
(8) Position the clock gauge
E
and make sure that the plunger
is pressed in at least 0.2 mm.
Secure the clock gauge and set it at zero.
Caution
D
When turning the engine with the gauge installed
you might damage the clock gauge.
NOTE
The measuring pin and guide bush can only be supplied
and used as a set.
(9) Turn the crankshaft
exactly
to TDC (clockwise).
To achieve this:
D Insert an 8 mm diameter locking pin in the hole of
torxbolt.
D Apply pressure just before TDC on this pin until it
engages the recess in the crankshaft.
(10)Now turn the flange with sprocket adaptor MB996037
counterclockwise until the adjustment value is obtained
as shown on th e pump ± 0.02 mm.
PWEE9602
E
July 1996Mitsubishi Motors Corporation
REN0149
REN0158
REN0159