F8QT ENGINE -
Fuel Injection Pump
11A-19-4
FUEL INJECTION PUMP ADJUSTMENT
MEASURING TOOL INSTALLATION
(1) Turn the crankshaft clockwise so that the piston of No.
1 cylinder (flywheel end) is at TDC, with the following
marks in line with each other:
D flywheel/clutch housing
D timing belt cover/camshaft sprocket.
(2) Remove cover
1
and the bolts of cover
2
.
(3) Locate sprocket stopper MB996043 between the pump
bracket and t h e sprocket. Secure the tool with the two
bolts supplied with the set.
Bolt
F
is not needed now.
ADJUSTMENT OF THE INJECTION TIMING
(1) Insert Hexagon socket spanner MB996036 in the nut
assembly. Loosen nut assembly (approx. 1/4 of turn
clockwise
) until it is possible to move the flange
2
.
(2) Remove sprocket stopper MB996043.
(3) Fit sprocket adaptor MB996037 in the three holes of the
flange.
Turn the tool with the flange until the jaws of the tool
engage the three internal recesses of the sprocket.
(4) Turn the tool by hand with the flange
clockwise
until
the stop.
Remove sprocket adaptor MB996037.
PWEE9602
E
July 1996Mitsubishi Motors Corporation
REN0148
REN0153
REN0154
MB996043
REN0155
MB996036
REN0156
MB996037