Filter
Top Products
F8QT ENGINE -
Intermediate Shaft and Intermediate Shaft Bearings
11A-17-2
REMOVAL SERVICE POINTS
A
A
"
INTERMEDIATE SHAFT SPROCKET REMOVAL
(1) Use sprocket stopper MB996034 to hold the sprocket
during removal.
(2) Remove the sprocket and th e sprocket key.
A
B
"
OIL PUMP DRIVE GEAR REMOVAL
(1) Remove the oil pump drive gear
7
with the aid of an
M12 bolt.
A
C
"
OUTER BEARING REMOVAL
(1) Remove the outer bearing
14
with bearing puller
MB996025.
A
D
"
INNER BEARING REMOVAL
(1) Remove the inner bearing
15
with bearing puller
MB996026.
INSTALLATION SERVICE POINTS
"
A
A
INNER BEARING INSTALLATION
(1) Install the inner bearing with the aid of bearing installer
MB996027.
The pin of the installer must engage the oil return passage
of the intermediate shaft
13
.
NOTE
Position the inner bearing with the opening at the mark
on the installer.
(2) Check with a piece of wire (1.2 mm diameter) that the
oil hole is aligned with the drilling in the bearing.
PWEE9602
E
July 1996Mitsubishi Motors Corporation
REN0146
MB996034
REN0092
REN0093
MB996025
REN0094
MB996026
REN0095
MB996027