Mitsubishi F8QT Automobile Parts User Manual


 
F8QT ENGINE -
Rocker Cover and Cylinder Head
11A-12-2
REMOVAL SERVICE POINTS
A
A
"
CYLINDER HEAD REMOVAL
(1) Release and then remove the cylinder head bolts.
(2) Lift the cylinder head straight up over the locating dowels
and then remove the cylinder head.
A
B
"
CYLINDER HEAD GASKET REMOVAL
Caution
D
When removing the cylinder head gasket, take care
not to scratch the cylinder head or cylinder block
gasket faces.
INSTALLATION SERVICE POINTS
"
A
A
CYLINDER HEAD GASKET INSTALLATION
(1) Select a cylinder head gasket of the correct thickness
according to the projecting height of the pistons. The
available cylinder head gaskets are shown in the table
below. The thickness of the gasket is indicated by the
number of holes near the en d of the gasket (see the
illustration). Measure the projecting height of the pistons
and calculate the average height. Then select a cylinder
head gasket of the correct thickness from the table shown
below.
Piston height
above cylinder
block mm
Number of holes Gasket thickness
mm
- 0.073 2 1.40
0.073 - 0.206 1 1.50
0.206 - 3 1.60
When only the gasket is to be replaced, check the hole
pattern on the old gasket and select a gasket with the
same number of holes.
Caution
D
If a piston or connecting rod, etc. has been
replaced, always measure the projecting height
of the pistons because this may have changed
after replacing these parts.
PWEE9602
E
July 1996Mitsubishi Motors Corporation
REN0041
REN0042