F8QT ENGINE -
Camshaft, Intake and Exhaust Valves
11A-13-8
(6) Clean the valve guide inner bores
22, 23
with reamer
MB996024.
"
D
A
VALVE STEM SEAL INSTALLATION
(1) Lubricate the valve guides
22, 23
with engine oil.
Introduce the valves
16, 17
through the valve guides.
Locate the protective plastic cap over the valve stem.
(2) Locate the valve stem oil seal
15
. Press in the valve
stem oil seal
15
vertically until it abuts the cylinder head
31
with valve stem seal installer MB996031. Remove
the protective cap.
Caution
D
To avoid damaging the valve stem oil seal, the
valves 16, 17 must not be removed again.
"
E
A
RETAINER LOCKS INSTALLATION
(1) Fit valve spring compressor MB996014 on the cylinder
head
31
as shown in the illustration.
(2) Press down the valve spring retainer
12
and fit the retainer
locks
11
.
"
F
A
CAMSHAFT BEARING CAPS INSTALLATION
(1) Apply a sealant to th e No. 1 and No. 5 bearing caps.
(2) Fit the camshaft bearing caps in the correct sequence
(the caps are numbered).
Apply a locking agent to the upper five bolts.
Tighten the bolts to the specified torques.
PWEE9602
E
July 1996Mitsubishi Motors Corporation
REN0072
MB996024
REN0073
MB996031
REN0074
MB996014
REN0075
REN0076