Mitsubishi F8QT Automobile Parts User Manual


 
F8QT ENGINE -
Intermediate Shaft and Intermediate Shaft Bearings
11A-17-3
"
B
A
OUTER BEARING INSTALLATION
(1) Install the outer bearing with the aid of bearing installer
MB996028.
The pin of the installer must engage the oil return passage
of the intermediate shaft
13
.
NOTE
Position the outer bearing with the opening at the mark
on the installer.
(2) Check with a piece of wire (1.2 mm diameter) that the
oil hole is aligned with the drilling in the bearing.
"
C
A
INTERMEDIATE SHAFT/LOCK PLATE
INSTALLATION
(1) Measure the clearance between the intermediate shaft
and the lock plate.
Replace the part in question if the clearance exceeds
the limit value.
(2) Install the intermediate shaft together with the lock plate.
"
D
A
INTERMEDIATE SHAFT OIL SEAL INSTALLATION
(1) Coat the lip of the oil seal with a thin layer of engine
oil.
(2) Locate the oil seal installer guide MB996039 over the
intermediate shaft.
(3) Locate the oil seal over the oil seal installer guide.
(4) Fit the oil seal with oil seal installer MB996039.
"
E
A
INTERMEDIATE SHAFT SPROCKET
INSTALLATION
(1) Use sprocket stopper MB996034 and tighten the retaining
bolt to 50 Nm.
PWEE9602
E
July 1996Mitsubishi Motors Corporation
REN0096
MB996028
REN0097
REN0098
MB996039
REN0146
MB996034
50Nm