Filter
Top Products
X
Select Yes or No.
When you select Yes, the current map data
will be overwritten.
When you select No, the DVD will be ejected
automatically and the installation process
is cancelled.
X
Remove the DVD from the slot.
Map data not installed yet
The versions of the map software on the DVD
and of the installed map software appear in
the COMAND display. You are then asked if
you want to install the map software.
X
Select Yes or No.
When you select Yes, the map data will be
installed.
When you select No, the DVD will be ejected
automatically and the installation process
is cancelled.
X
Remove the DVD from the slot.
When an activation code is required, you will
be prompted to enter it.
X
Enter the activation code and confirm by
pressing !.
Installation of the map software starts.
When you enter an invalid activation code,
you are prompted to reenter the activation
code. After entering an invalid activation code
for the third time, the prompt for reentering
the activation code will be delayed. The delay
increases by 5 minutes each time an invalid
activation code is entered to a maximum
delay of 5 hours.
Map software installation
Immediately before installation, the
COMAND system reboots.
A corresponding message and a progress bar
appear during the installation process.
X
Canceling installation on the DVD
changer: Press the respective magazine
tray button.
X
Remove the DVD from the slot.
i
When you cancel the installation, the
navigation system will be inoperative. You
can resume a canceled installation at a
later time.
X
Installation of multiple DVD map
software: After installation of the first
DVD, a message appears that prompts you
to insert the next DVD. Follow the
instructions on the COMAND display.
X
Continue installation without
canceling: Let the installation continue
without pressing any buttons.
When the installation has been completed,
a corresponding message appears.
X
Confirming message: Press W.
The DVD is ejected.
X
Remove the DVD from the slot.
The installation is finished.
When the installation has been completed
successfully, a corresponding message
appears.
X
Confirming message: Press W.
The DVD is ejected.
X
Remove the DVD from the slot.
If the installation was unsuccessful:
R
The DVD is dirty or scratched.
X
Clean the DVD (Y page 165).
X
Start the installation of the map
software once more.
R
The system may be overheated due to
excessive temperature in the vehicle
interior.
COMAND navigation (introduction)
85
Control systems
216_AKB; 3; 90, en-US
d2ureepe, Version: 2.11.8.1
2009-05-15T11:47:50+02:00 - Seite 85
Z