Filter
Top Products
X
Press button a again if you would like
to change the current status.
Depending on the previous status, Blind
Spot Assist will be Enabled or Disabled
For more information on Blind Spot Assist,
see (Y page 335).
Service menu
In the Service menu the following functions
are available:
R
Vehicle status message memory
(Y page 214)
R
Checking tire inflation pressure
electronically with the Advanced TPMS
(Y page 377)
R
Calling up the maintenance service
indicator display (Y page 402)
R
Checking engine oil level (CL 600 and
CL 65 AMG) (Y page 370)
Vehicle status message memory
Use the vehicle status message memory
function to scan malfunction and warning
messages that may be stored in the system.
Such messages appear in the multifunction
display and are based on conditions or
system status the vehicle’s system has
recorded.
The vehicle status message memory function
only appears if there are any messages
stored.
G
Warning!
Malfunction and warning messages are only
indicated for certain systems and are
intentionally not very detailed. The
malfunction and warning messages are
simply a reminder with respect to the
operation of certain systems. They do not
replace the owner’s and/or driver’s
responsibility to maintain the vehicle’s
operating safety. Have all required
maintenance and safety checks performed on
the vehicle. Bring the vehicle to an authorized
Mercedes-Benz Center to address the
malfunction and warning messages.
X
Press button = or ; to select the
Service menu.
If conditions have occurred causing status
messages to be recorded, the number of
messages appears in the multifunction
display: 2 Messages.
X
Press button : or 9 to select the
Messages function.
X
Press button a to confirm.
For malfunction and warning messages,
see “Vehicle status messages in the
multifunction display” (Y page 414).
X
Use button : or 9 to scroll through
the messages.
If you turn the SmartKey in the starter switch
to position 0 and then back to position 2, all
messages will be deleted from the message
memory.
Settings menu
In the Settings menu the following functions
are available:
R
Switching daytime running lamp mode on
or off (USA only) (Y page 215)
R
Showing or hiding additional speedometer
(Y page 215)
R
Selecting speedometer display mode
(Y page 215)
R
Switching the radar sensors on or off
(Y page 216)
214
Instrument cluster control system
Control systems
216_AKB; 3; 90, en-US
d2ureepe, Version: 2.11.8.1
2009-05-15T11:47:50+02:00 - Seite 214