Filter
Top Products
X
Selecting a city: Slide ZVÆ or rotate
cVd.
X
Canceling selection: Select Back and
press W.
or
X
Press back button % in the center
console (Y page 75).
X
Confirming selection: Press W.
Cities with symbol : are available more
than once within the selected state (USA)
or province (Canada). Confirming one of
these cities will take you to a further sub-
selection.
Select one of the available cities or select
All. For more information, see “Multiple
hits for city name ” (Y page 100).
If there are no other selection options, the
address input menu appears again.
It shows one of the following items of
information:
R
City and state (USA) or province (Canada)
R
Street, city and state (USA) or province
(Canada)
i
The street is visible if you have entered it
before entering the city.
Which of the following menu items are now
available depends on the situation, or may
depend on the digital map. The menu items
which are not available cannot be selected.
R
Map: Using the map to enter a destination
(Y page 109)
i
In this case, using the map for destination
entry is based on the city seen in the
address input menu.
R
Street: Entering the street (Y page 101)
R
No.: Entering the house number
(Y page 104)
R
Center: Entering the center (Y page 103)
R
Intersection: Entering the intersection
(Y page 105)
R
POI: Entering a point of interest
(Y page 111)
i
In this case, entering a POI is based on the
city seen in the address input menu.
R
Save: Saving a destination in the
destination memory (Y page 132)
R
Start: Starting the route calculation
(Y page 107)
X
Continuing or completing destination
entry: Select one of the menu items
mentioned above.
Selecting the current city
The entry “City” in the “Address” menu is
always empty at first because you can enter
the street before entering a city
(Y page 102). You can modify the last
entered destination such as selecting another
street in the last city.
X
Destination Q From Last
Destinations
X
Select the last destination.
X
Select Change and press W.
Multiple hits for city name
When there are multiple cities with the same
name, you can enter or select a street name
in addition. COMAND will then select the city
in which the entered street name exists.
X
Enter a city (Y page 98).
X
Select ALL.
X
Enter or select the street name.
X
Select the desired city.
100
COMAND navigation system (entering a destination)
Control systems
216_AKB; 3; 90, en-US
d2ureepe, Version: 2.11.8.1
2009-05-15T11:47:50+02:00 - Seite 100