Filter
Top Products
outgoing call, the No Service message will
appear for a short while.
R
The SIM card is not inserted in GSM type
phone.
R
When you remove the SmartKey from the
starter switch during a call in hand-free
mode, the call will be maintained for up to
30 minutes. It will then be terminated.
Switch to “Private Mode” on the mobile
phone before switching off COMAND to
maintain the call beyond that time limit.
Refer to the operating instructions of your
mobile phone.
R
When you want to switch off COMAND
during a call in hands-free mode, the
message You cannot shut off COMAND
until you have finished your
telephone call. appears.
Activating telephone mode
X
Select Telephone.
or
X
Press button 6 on telephone keypad.
or
X
Press shortcut button S once or twice.
i
The number of times you have to press
shortcut button S depends on the
operating mode currently selected.
Telephone keypad
With the telephone keypad : you can:
R
Enter and clear numbers and special
characters.
R
Reject, answer, connect and end calls.
X
Entering characters: Flip up cover ;.
X
Enter characters using buttons ´ -
Æ.
i
You can enter the * character by pressing
button à once. Pressing button Ã
again within 1.5 seconds enters the +
character.
X
Deleting individual characters: Press
button $.
X
Deleting an entire word or number:
Press and hold button $ until the word
or number is deleted.
“911” emergency call
i
The “911” emergency call system is a
public service. Using it without due cause
is a criminal offense.
i
This function places a call to the local
“911” provider. It does not initiate a Tele
Aid call.
The following describes how to dial a “911”
emergency call using the COMAND head unit
when a Mercedes-Benz specified mobile
phone is connected via the Bluetooth
®
interface to COMAND. Unless otherwise
specified, the descriptions refer to the
COMAND head unit.
Consult the separate mobile phone operating
instructions that came with your mobile
phone for information on how to place a
“911” emergency call on the mobile phone.
COMAND telephone
137
Control systems
216_AKB; 3; 90, en-US
d2ureepe, Version: 2.11.8.1
2009-05-15T11:47:50+02:00 - Seite 137
Z