Filter
Top Products
142
Reset Trim Calibration
If you are not satisfied with your engine trim calibration, you can reset
engine trim calibration from the Suzuki Engine Interface Advanced
Options menu.
1. Press
MENU|MENU, select NMEA 2000 and press ENT.
2. Choose
BUS SETUP and press ENT. Select the Suzuki Engine Interface
connected to the desired engine and press
ENT.
3. Highlight
ADVANCED OPTIONS and press ENT. Select Reset TRIM CALIBRA-
TION
and press ENT. The following message will appear: Do you wish to
re-calibrate the device?
4. Highlight
YES and press ENT. Press EXIT repeatedly to get back to the
main display.
Bennett Trim Tabs Calibration
Trim Tabs will be calibrated through their Device Configuration menu.
To calibrate Trim Tabs:
1. Press MENU|MENU, select BUS SETUP and press ENT. A list of network
devices will appear.
2. Select
BENNETT TRIM TABS from the list and press ENT, which will open
the Trim Tab Device Configuration menu.
3. Highlight
CALIBRATE and press ENT. The Device Calibration window
will appear with a list of calibration instructions.
4. Select
START CALIBRATION and press ENT. The following message will
appear: Please fully raise Trim Tabs.
5. After fully raising the trims tabs, press
ENT. The following message
will appear: Please fully lower trim tabs.
6. After fully lowering the trim tabs, press
ENT. A Calibration Complete
message will appear. Press
ENT. Press EXIT repeatedly to return to the
main display.
To Reset Calibration:
1. Press MENU|MENU, select NMEA 2000 and press ENT.
2. Highlight
FUEL MANAGEMENT and press ENT.
3. Highlight
ENGINE SELECT and press ENT. The Engine Select menu will
appear with up to four options: All Engines, Port, Center and Star-
board. Selecting All Engines will reset calibration for all engines back
to factory defaults.
4. Select All Engines or the engine connected to the desired device and
press
ENT.