Filter
Top Products
Garmin G1000 Cockpit Reference Guide for the DA40/40F
SECTION 6 – AUTOMATIC
FLIGHT CONTROL
6-15
Intercepting a VOR Radial
NOTE: Changing the HSI mode cancels
Navigation Mode and causes the flight
director to revert to Roll Hold Mode.
During climb-out, the autopilot continues to fly the
aircraft in Heading Select Mode. Airway V107 to Panoche
VORTAC (PXN) should now be intercepted.
1) Tune the VOR frequency and activate Heading
Select Mode.
a) Use the
CDI Softkey to set the HSI mode to
VOR.
b) Use the
CRS Knob to set the Selected Course
to 116°. Note that at this point, the flight
director is still in Heading Select Mode and
the autopilot continues to fly 070°.
Figure 6-21 Intercepting a VOR
1.
2.
3.
2
9
6
0
3
6
9
12
1
5
1
8
21
2
4
2
7
3
0
33
H
D
G
M
od
e,
V
OR
A
r
m
ed
0
7
0
V
OR
M
o
d
e
V
10
7
P
a
no
che
�
V
O
R
T
A
C
�
(P
X
N
)
c) Press the
NAV
Key to arm Navigation Mode.
The white annunciation ‘VOR’ appears to
the left of the active roll mode.
2) When the CDI shows less than one dot, the
flight director changes from Heading Select to
Navigation Mode, and the green annunciation
‘VOR’ flashes. The autopilot begins turning to
intercept the Selected Course.
3) The autopilot continues the turn until the aircraft
is established on the Selected Course.