Filter
Top Products
Garmin G1000 Cockpit Reference Guide for the DA40/40F
SECTION 6 – AUTOMATIC
FLIGHT CONTROL
6-11
Navigation Mode (GPS, VOR, LOC, or BC)
Pressing the NAV Key activates the Navigation Mode.
The Navigation mode acquires and tracks the selected
navigation receiver on the HSI (e.g. GPS, VOR or LOC).
GPS roll steering commands are followed when the HSI
is in GPS mode, and creates roll steering commands from
the Selected Course and deviation when the HSI is in
VOR, LOC, or BC (backcourse) modes.
Turning the CRS Knob moves the Course Pointer when
in VOR, LOC, and OBS mode, and displays the Selected
Course Box. The Selected Course is displayed in the
box. The box is displayed while the knob is turning and
disappears three seconds after the knob stops turning.
Backcourse mode is automatically selected when the
localizer front course is greater than 105 degrees from the
aircraft heading.
NOTE: When making a backcourse approach, set
Selected Course to the localizer front course.
Figure 6-17 Navigation Mode
Flight Level Change mode is active
Flight Director command
bars indicating a left
turn to track GPS course
and a climb to intercept
Selected Altitude
Navigation Mode is active using GPS source
GPS is active
navigation receiver
on the HSI
Selected Course
Altitude Hold is armed
Navigation Mode Armed
If the CDI is not centered (deviation >1 dot) when the
Navigation mode is selected, the mode is automatically
armed. The armed annunciation appears in white to the
left of the active roll axis mode.
See the Example Procedures Using AFCS section for
more information.