Filter
Top Products
Appendix A
46
Attaching the External Speaker System with 12/24v DC Adapter to the StreetPilot
2610/2650
1. Locate the power connector on the rear of the StreetPilot 2610/2650. The connector is “keyed” with a
notch located towards the bottom of the plug.
2. Mate the power plug on the External Speaker System with 12/24v DC Adapter to this connector by aligning
the notches and sliding the plug into the connector until fully seated. (see fi gures to the left)
3. Plug the cigarette lighter portion of the External Speaker System with 12/24v DC Adapter into an available
cigarette lighter receptacle in your vehicle. Use care when routing the adapter cable being certain that it
does not interfere with vehicle operation in any way.
Attaching the DR (Dead Reckoning) Cable to the External Speaker System with 12/24v
DC Adapter for the StreetPilot 2650 only
1. Locate the DR connector on the side of the External Speaker System with 12/24v DC Adapter. The connec-
tor is “keyed” with a large and small receptacle.
2. Mate the DR plug to the connector on the External Speaker System with 12/24v DC Adapter and push the
plug into the connector until fully seated.
Non-Skid Friction Mount Base
The non-skid friction mount base is designed to fi t an uneven surface. Each of the four weighted tabs
can be bent to fi t the shape of your vehicle’s dash. By fi tting the base to your vehicle’s dash, you maximize
the contact area and minimize the likelihood that the StreetPilot would slide when making sharp turns.
mounting base
weighted tabs
locking lever release tab
Vehicle Installation
2610_2650 OM.indd 46 8/1/2003, 4:16:09 PM