Filter
Top Products
Navigation Audio System
Notice: Before adding any sound equipment to your
vehicle, such as an audio system, CD player, CB
radio, mobile telephone, or two-way radio, make sure
that it can be added by checking with your dealer.
Also, check federal rules covering mobile radio and
telephone units. If sound equipment can be added,
it is very important to do it properly. Added sound
equipment may interfere with the operation of your
vehicle’s engine, radio, or other systems, and even
damage them. Your vehicle’s systems may interfere
with the operation of sound equipment that has been
added.
Notice: The chime signals related to seat belts,
parking brake, and other functions of your vehicle
operate through the navigation system. If that
equipment is replaced or additional equipment is
added to your vehicle, the chimes may not work.
Make sure that replacement or additional equipment
is compatible with your vehicle before installing it.
See “Accessories and Modifications” in the Index of
your vehicle’s owner manual.
Your vehicle has a feature called Retained Accessory
Power (RAP). With RAP, the audio system can be played
even after the ignition is turned off. See “Retained
Accessory Power (RAP)” in the Index of your vehicle’s
owner manual for more information.
The audio system is operated using navigation system
menus. The audio menus are explained in this section.
Playing the Radio
On
(Power/Volume): Press this knob to turn the
audio system on and off. Turn the knob to increase or to
decrease the volume to the audio system.
BAND: Press this key to access the audio source
screen. Then press this key to switch between AM, FM,
WX (weather), or XM (if equipped).
AUX (Auxiliary): Press this key to play the video and
audio devices connected to the auxiliary jacks. See
Auxiliary Devices on page 3-25 for more information.
SRCE (Source): Press this key to change the audio
source from the radio band to CD, audio DVD, or video
DVD, depending on what is loaded in the six-disc DVD
changer, or from DVD/CD to radio mode.
e (Audio): Press this key to view the AUDIO ADJUST
screen. See “Audio Adjust” screen later in this section.
ǻ (Seek/Scan): To seek stations, press the up or
down arrow to go to the next or previous station and
stay there.
To scan stations, press and hold either arrow for less
than 2 seconds. The radio will go to a station, play for a
few seconds, then go on to the next station. To stop
scanning, press either arrow again or touch the scan
screen button.
Tuning Knob: Turn this knob to change frequencies.
3-2