Filter
Top Products
Voice Recognition Commands
The following list shows all of the voice commands
available for the navigation system with a brief description
of each. The commands are listed with the optional words
in brackets. To use the voice commands, refer to the
instructions listed previously.
Display Commands
Display [set] English units: This command instructs
the system to switch to English units of measurement.
All display settings will change.
Display [set] metric units: This command instructs
the system to switch to metric units of measurement.
All display settings will change.
Display [set] day mode: This command instructs
the system to switch the system display to day mode.
See “Screen Appearance” under Configure Menu
on page 2-50 for more information.
Display [set] night mode: This command instructs
the system to switch the system display to night mode.
See “Screen Appearance” under Configure Menu on
page 2-50 for more information.
Display [set] auto mode: This command instructs
the system to switch the system display to auto mode.
See “Screen Appearance” under Configure Menu
on page 2-50 for more information.
Display Help: This command instructs the system
to offer assistance with the previously listed display
commands. The Navigation System will display
the commands on the screen.
General Navigation Commands
Navigation [show] current position, navigation
[show] current location: This command instructs
the system to show your vehicle’s current position on
the map.
Navigation [show] map: This command instructs the
system to show the current map screen.
Navigation [command] help, navigation [command]
list: This command instructs the system to state the
navigation command help list.
Navigation repeat [voice] [guidance]: This command
instructs the system to repeat the previous voice
guidance prompt.
Cancel: This command instructs the system to cancel
the most recently given command.
4-5