Filter
Top Products
Matrix Modules Command Reference 73Chapter 4
SYSTem:CPON
SYSTem:CPON <number> | ALL sets the selected module (card) in a
switchbox to its power-on state.
Parameters
Comments Matrix Module Power-on State: The power-on state is all channels (relays)
open. *RST opens all channels of all modules in a switchbox, while
SYSTem:CPON <number> opens the channels in only the module (card)
specified in the command.
Example Setting Module to Power-on State
SYST:CPON 1
! Set card #1 to power-on state
SYSTem:CTYPe?
SYSTem:CTYPe? <number> returns the module (card) type of a selected
module in a switchbox.
Parameters
Comments
E1465A Matrix Module Model Number: SYSTem:CTYPe? <number> returns:
HEWLETT-PACKARD,E1465A,0,A.04.00
where the 0 after E1465A is the module serial number (always 0) and
A.04.00 is an example of the module revision code number.
E1466A Matrix Module Model Number: SYSTem:CTYPe? <number> returns:
HEWLETT-PACKARD,E1466A,0,A.04.00
where the 0 after E1466A is the module serial number (always 0) and
A.04.00 is an example of the module revision code number.
Name Type Range of Values Default Value
<number> numeric
1 through 99 | ALL N/A
Name Type Range of Values Default Value
<number> numeric
1 through 99 N/A