Filter
Top Products
70 Matrix Modules Command Reference Chapter 4
STATus:OPERation:CONDition?
STATus:OPERation:CONDition? returns the state of the Condition Register
in the OPERation Status Register. The state represents conditions that are
part of the instrument's operation. The switch module driver does not set bit
8 in the OPERation Status Register (see STATus:OPERation[:EVENt]?).
STATus:OPERation:ENABle
STATus:OPERation:ENABle <unmask> sets an enable mask to allow events
recorded in the Event Register of the OPERation Status Register to send a
Summary bit to the Status Byte Register (bit 7). For matrix modules, when
bit 8 in the OPERation Status Register is set to 1 and bit 8 is enabled by
STATus:OPERation:ENABle, bit 7 in the Status Byte Register is set to 1.
Parameters
Comments Setting Bit 7 of the Status Byte Register: STATus:OPERation:ENABle 256
sets bit 7 (OPR) of the Status Byte Register to 1 after bit 8 (Scan Complete)
of the OPERation Status Register is set to 1.
Related Commands: [ROUTe:]SCAN
Example Enabling OPERation Status Register Bit 8
STAT:OPER:ENAB 256
! Enable bit 8 of the OPERation
Status Register to be reported to
bit 7 (OPR) in the Status Byte
Register
STATus:OPERation:ENABle?
STATus:OPERation:ENABle? returns the bit value of the Enable Register
within the OPERation Status Register.
Comments Output Format: STATus:OPERation:ENABle? returns a decimal-weighted
value from 0 to 65,535 indicating the bits set to true.
Maximum Value Returned: The value returned is the value set by
STATus:OPERation:ENABle <unmask>. However, the maximum
decimal-weighted value used in this module is 256 (bit 8 in the Condition
Register within the OPERation Status Register is set to true).
Name Type Range of Values Default Value
<unmask> numeric
0 through 65,535 N/A