Filter
Top Products
Configuring the Matrix Modules 27Chapter 2
Wiring the Terminal
Modules
Figures 2-8 and 2-9 give guidelines to connect user wiring to the terminal
module assembly. Expansion connectors allow you to create larger
matrixes. See "Configuring Larger Matrixes" for details.
User wiring to the matrix modules is to the High (H) and Low (L) terminal
connections. Maximum terminal wire size is No. 16 AWG. Wire ends should
be stripped 6 mm (0.25 in.) and tinned. When wiring all channels, use a
smaller gauge wire (No. 20 - 22 AWG).
Continued on next page
Figure 2-8. Wiring the Terminal Module
Remove clear cover.1 Remove and retain wiring exit panel.2
Make connections.3 Route wiring.4
A. Release screws.
B. Press tab forward
and release.
Tab
Remove 1 of the 3
wire exit panels.
size 16-26
AWG
5mm
0.2"
Use wire
VW1 Flammability
Rating
Insert wire into terminal.
Tighten screw.
Screw type
Tighten wraps to
secure wires.