Filter
Top Products
Fuses
335
keep in mind that a considerably higher
degree of effort is necessary to brake and
steer the vehicle. Adapt your driving
accordingly.
X
Make sure the ignition is switched on.
X
With the vehicle at a standstill, depress the
brake pedal and keep it pressed.
X
Vehicles with manual transmission: Shift
the manual transmission into the neutral
position (no gear selected).
or
X
Vehicles with automatic transmission: Shift
the automatic transmission into neutral
position N.
X
Release the brake pedal.
X
If engaged, release the parking brake.
X
Switch on the hazard warning flasher
(Y page 85).
!
The vehicle may be towed only for distan-
ces up to 30 miles (50 km) and at a speed
not to exceed 30 mph (50 km/h).
i
To signal turns while being towed with the
hazard warning flasher in use you can acti-
vate the combination switch for the left or
right turn signal in the usual manner – only
the selected turn signal will operate. Upon
canceling the turn signal, the hazard warn-
ing flasher will operate again.
Fuses
Introduction
The electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and sys-
tems secured by that fuse will stop operating.
G
Warning!
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system
in question and do not attempt to repair or
bridge a blown fuse. Using other than
approved fuses or using repaired or bridged
fuses may cause an overload leading to a
fire, and/or cause damage to electrical
components and/or systems. Have the
cause determined and remedied by an
authorized Mercedes-Benz Center.
A blown fuse must be replaced by an appro-
priate spare fuse (recognizable by its color or
the fuse rating given on the fuse) of the
amperage recommended in the fuse chart.
Any Mercedes-Benz Center will be glad to
advise you on this subject.
i
In case of a blown fuse contact Roadside
Assistance or an authorized Mercedes-
Benz Center.
Practical hints