Filter
Top Products
Useful features
214
Garage door opener
The integrated remote control can operate up
to three separately controlled devices com-
patible with HomeLink
®
or some other sys-
tems.
See the following instructions for program-
ming information.
Overhead control panel with integrated remote
control
1
Indicator lamp
234
Signal transmitter button
5
Hand-held remote control (not part
of vehicle equipment)
6
Hand-held remote control button
G
Warning!
Before programming the integrated remote
control to a garage door opener or gate
operator, make sure people and objects are
out of the way of the device to prevent
potential harm or damage. When program-
ming a garage door opener, the door moves
up or down. When programming a gate
operator, the gate opens or closes.
Do not use the integrated remote control
with any garage door opener that lacks
safety stop and reverse features as
required by U.S. federal safety standards
(this includes any garage door opener
model manufactured before April 1, 1982).
A garage door that cannot detect an object
- signaling the door to stop and reverse -
does not meet current U.S. federal safety
standards.
When programming a garage door opener,
park vehicle outside the garage.
Do not run the engine while programming
the integrated remote control. Inhalation of
exhaust gas is hazardous to your health. All
exhaust gas contains carbon monoxide
(CO), and inhaling it can cause uncon-
sciousness and possible death.
Programming the integrated remote
control
X
Step 1: Switch on the ignition.
X
Step 2: If you have previously programmed
a signal transmitter button and wish to
retain its programming, proceed to step 3.
or
X
If you are programming the integrated
remote control for the first time, press and
hold the two outer signal transmitter but-
tons 2 and 4 and release them only when
indicator lamp 1 begins to flash after
approximately 20 seconds (do not hold the
button for longer than 30 seconds).
This procedure erases any previous set-
tings for all three channels and initializes
the memory. If you later wish to program a
second and/or third hand-held transmitter
to the remaining two signal transmitter but-
tons, do not repeat this step and begin
directly with step 3.
X
Step 3: Hold the end of hand-held remote
control 5 of the device you wish to train
approximately 2 to 12 in (5 to 30 cm) away
from the signal transmitter button (2, 3
or 4) to be programmed, while keeping
indicator lamp 1 in view.
Controls in detail