Filter
Top Products
Control system
127
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approxi-
mately 14 m) every second.
Never operate radio transmitters equipped
with a built-in or attached antenna (i.e.
without being connected to an external
antenna) from inside the vehicle while the
engine is running. Doing so could lead to a
malfunction of the vehicle’s electronic sys-
tem, possibly resulting in an accident and/
or personal injury.
You can connect your telephone via Blue-
tooth
®
to the audio system (Y page 169) or
to the COMAND system, see separate
COMAND system operating instructions.
X
Switch on the audio system (Y page 128)
or the COMAND system, see separate
COMAND system operating instructions.
X
Press button ÿ or è on the multi-
function steering wheel repeatedly until the
Telephone menu appears in the multifunc-
tion display.
One of the following messages will appear
in the multifunction display:
R
No Service: No network is available.
R
Bluetooth Ready: The telephone has
not been connected to the audio system
or COMAND system via Bluetooth
®
yet.
X
Connect the telephone to the audio
system or COMAND system via
Bluetooth
®
.
R
Ready or name of the network provider
(if available): The telephone has found a
network and is ready for use. You can
operate it using the control system.
Answering a call
When your telephone is ready to receive calls,
you can answer a call at any time. In the mul-
tifunction display you will then see the mes-
sage, or if available, the caller ID (number and
name):
X
Press button s.
You have answered the call.
Ending a call or rejecting an incoming
call
X
Press button t.
Dialing a number from the phone book
If your telephone is ready to receive calls, you
may select and dial a number from the phone
book. You can add new numbers to the phone
book with the telephone, see separate oper-
ating instructions.
X
Press button ÿ or è on the multi-
function steering wheel repeatedly until the
Telephone menu appears in the multifunc-
tion display.
X
Press button j or k repeatedly until
the desired name appears in the multifunc-
tion display.
If you press and hold button j or
k for longer than 1 second, the system
scrolls rapidly through the list of names
until you release the button again.
The stored names are displayed in ascend-
ing or descending alphabetical order.
Controls in detail