Filter
Top Products
564
Operation
Tires and wheels
̈ Switch on the ignition (୴ page 344).
̈ Press ( or & to select the menu
“Service”.
̈ Press $ or % to select “Tire
pressure”.
̈ Press #.
You will see
ț the current inflation pressures for
each tire
or
ț the message
“Tire pressures
displayed after driving
a few minutes”
appear in the multifunction display.
̈ Press %.
The message
“Use current pressure
values as new
reference values
To confirm press "OK"”
appears in the multifunction display.
̈ Press #.
The message
“Tire pressure monitor
restarted”
appears in the multifunction display.
After a few minutes driving, the current
tire inflation pressure values are ac-
cepted as reference values and then
monitored.
If you wish to cancel activation:
̈ Press L.
or
̈ Press $ to exit menu screen.
i
Reactivate the TPMS after adjusting the tire
inflation pressure to the inflation pressure rec-
ommended for the vehicle operating condition.
Tire inflation pressure should only be adjusted
on cold tires. Observe the recommended tire in-
flation pressure on the Tire and Loading Informa-
tion placard on the driver’s door B-pillar
(
୴ page 553). Some vehicles may have supple-
mental tire inflation pressure information for
driving at high speeds (
୴ page 559) or for vehi-
cle loads less than the maximum loaded vehicle
condition. If such information is provided, it can
be found on the inside of the fuel filler flap
(
୴ page 538).
i
After wheel rotation or sensor replacement,
the vehicle must be parked for 20 minutes be-
fore attempting to reactivate the TPMS.
i
The menu overview can be found on
(
୴ page 266).
i
When the wheel positions are changed on
the vehicle, it is possible that the air pressure is
temporarily displayed for the wrong position.
This will be corrected after driving for several
minutes, and the air pressure will be shown for
the correct position.
୴୴