Filter
Top Products
186
Control systems
COMAND navigation system (entering a destination)
̈ Canceling an entry: Select “Back” in
the bottom line and press n.
or
̈ Press back button L in the center
console (
୴ page 86).
̈ Confirming entry: Select ? in the
second line from the bottom and
press n.
If COMAND cannot clearly attribute the
house number to a town or city, the
town/city input menu appears.
̈ Entering town: Proceed as de-
scribed in the “Entering a town or
city” section (
୴ page 178).
After the town or city has been en-
tered, the address input menu ap-
pears again.
If COMAND can clearly attribute the
house number to a town or city, the ad-
dress input menu also appears.
In both cases, the address input menu
shows the house number, street,
town/city and state (USA) or province
(CDN).
Which of the following menu items are now
available may depend on the data version
of the digital map. The menu items which
are not available cannot be selected.
ț “Map”: using the map to enter a desti-
nation (
୴ page 193)
ț “POI”: entering a point of interest
(
୴ page 196)
ț “Save”: saving a destination in the des-
tination memory (
୴ page 217)
ț “Start”: starting the route calculation
(
୴ page 190)
̈ Continuing or completing destina-
tion entry: Select one of the menu
items mentioned above.
With the street and town/city previously
entered
̈ In the address input menu, select
“House No.”.
The list of house numbers appears ei-
ther with or without the input charac-
ters (
୴ page 188). Whether or not the
input characters appear depends on
how many house numbers are available
in the selected street.
i
In this case, using the map for destination
entry is based on the town or city seen in the ad-
dress input menu.
i
In this case, entering a POI is based on the
town or city seen in the address input menu.
୴୴