Mercedes-Benz 2008 S600 Automobile User Manual


 
431
Controls in detail
Driving systems
ț if ESP
®
is switched off
ț if the hood is open
ț if the driver’s door is open and the driv-
er has not fastened his or her seat belt
ț if the radar sensors are switched off
(
page 282).
Switching on while driving
̈ Tap DISTRONIC Plus lever up 1 or
down 2 until desired speed is set.
DISTRONIC Plus is switched on.
or
̈ Pull DISTRONIC Plus lever briefly in di-
rection of arrow 4 to call up speed
last set (
page 435).
DISTRONIC Plus is switched on.
̈ Take your foot off the accelerator ped-
al.
Your vehicle adapts its speed to the ve-
hicle ahead, observing the set speed as
a maximum value.
Switching on when approaching a sta-
tionary vehicle
If the vehicle in front of you is stationary,
you can only switch on DISTRONIC Plus if
your vehicle is also at a standstill.
̈ Tap DISTRONIC Plus lever up 1 or
down 2 until desired speed is set.
DISTRONIC Plus is switched on.
or
̈ Pull DISTRONIC Plus lever briefly in di-
rection of arrow 4 to call up speed
last set (
page 435).
DISTRONIC Plus is switched on.
i
Under 20 mph, you can only switch on
DISTRONIC Plus if the vehicle ahead of you has
been detected and is shown on the multifunction
display. If you no longer see the vehicle in front
of you on the multifunction display and if it is no
longer detected because it has changed lanes,
for example, DISTRONIC Plus switches off and
you will hear a signal.
i
If you do not completely lift your foot off the
accelerator pedal, the message“DISTRONIC
PLUS override” appears on the multifunction dis-
play. The distance to a slower-driving vehicle will
not be set. You will drive at the speed you dictate
by pressing the accelerator pedal.
i
It is helpful to switch on the DISTRONIC Plus
display in the instrument cluster (
page 428)
since you can only switch on DISTRONIC Plus un-
der a speed of 20 mph when a vehicle has been
detected in front of you.
i
You can adjust the set speed using the
DISTRONIC Plus lever and the target distance
using the distance setting switch on the
DISTRONIC Plus lever (
page 436). ୴୴