Filter
Top Products
184
Control systems
COMAND navigation system (entering a destination)
While the characters are being selected as
described below, the top list entry 1 al-
ways shows the center which best corre-
sponds to the input data as it has been
entered up to that point.
At the same time, COMAND automatically
supplements characters 2 entered by the
user with appropriate characters 3.
̈ Selecting characters: Slide omp or
rotate ymz.
̈ Confirming character selection:
Press n.
̈ Deleting individual characters:
Select ) in the bottom line and
press n.
̈ Deleting an entire entry: Select ) in
the bottom line and press n until the
entire entry is deleted.
̈ Canceling an entry: Select “Back” in
the bottom line and press n.
or
̈ Press back button L in the center
console (
୴ page 86).
As soon as COMAND can clearly attribute
the characters entered to a center, the in-
put characters 7 disappear. You see the
list of centers without the input characters.
Here you can confirm the current entry or
make another selection.
During character entry, you can also man-
ually switch to the list of centers without
input characters at any time.
̈ Switching manually to the list of
centers without input characters:
Slide qm.
or
̈ Select ? in the second line from the
bottom and press n.
List of centers without input characters
̈ Selecting a center: Slide qmr or
rotate ymz.
̈ Canceling selection: Select “Back”
and press n.
or
̈ Press back button L in the center
console (
୴ page 86).
̈ Confirming selection: Press n.
After the confirmation, the address in-
put menu appears again. It shows the
center, town/city and state (USA) or
province (CDN).
i
In the list of input characters 7, you can
only select currently selectable characters.
Which characters are included depends on the
sequence in which you have entered your desti-
nation and the data version of the digital map.