Filter
Top Products
292
Control systems
Voice Control* telephone
“Correction”
Using the command “Correction” will cor-
rect the last entered digit block. After
speaking the command, the last digit block
is deleted and all previously entered digits
are repeated. The system then prompts
you to continue your input.
Sample dialog:
s Dial number
t Please say the number
s One two three
t One two three
s Four five six seven
t Five five six seven
s Correction
t One two three, please continue
s Four five six seven
t Four five six seven
s OK
t Dialing
“Delete”
Using the command “Delete” will erase all
digits entered. The system then prompts
you to start your input again.
Sample dialog:
s Dial number
t Please say the number
s One two three
t One two three
s Four five six seven
t Four five six seven
s Delete
t Number deleted. Please enter the
number again
s Four two seven three
t Four two seven three
s Three nine one
t Three nine one
s OK
t Dialing
“Redial”
Use the command “Redial” to dial the last
dialed number.
“Save name” (COMAND address book)
Use the command “Save name” to create a
new entry in your COMAND address book.
After using the command, the system will
prompt you to enter a phone number.
Digits from “Zero” to “Nine” can be en-
tered (
୴ page 291).
Speak the telephone number
ț as a continuous string
or, with longer phone numbers,
ț in form of digit blocks (three to five dig-
its).
After each digit block (separate the digit
blocks by using an approximately
0.5 second pause), the Voice Control Sys-
tem repeats the recognized digits and
waits until you continue speaking.