Filter
Top Products
99
Control systems
COMAND introduction
Adjusting surround sound
With surround sound, you can choose be-
tween “LOGIC7
®
ON” and “LOGIC7
®
OFF”.
̈ Select “Sound” Ǟ “3D Sound”.
Adjusting surround sound
1 Current setting
̈ Selecting a setting: Slide rmq or
rotate ymz.
̈ Saving setting: Press n.
The setting is saved and the menu is
closed.
̈ Exiting menu without saving
changes: Press L or slide omp.
Switching off/on the audio source
̈ Switching off: Select “Audio” Ǟ “Au-
dio” Ǟ “Audio OFF”.
The audio source is switched off; “Au-
dio OFF” appears in the display.
̈ Switching on: Select “Audio”, then the
desired audio source.
or
̈ Load CD/DVD (୴ page 115) or a
PCMCIA card (
୴ page 117).
i
By selecting “LOGIC7
®
OFF”, all compatible
formats as they are present on the medium are
played back. Due to the vehicle’s spatial charac-
teristics, an optimal sound experience is not en-
sured on all seats.
i
Please note the following:
ț For an ideal sound experience at all seats,
the balance and fader should be adjusted to
the center of the passenger compartment
with LOGIC7
®
switched on.
ț The best sound results are achieved by play-
ing high-quality audio CDs and audio DVDs.
ț For MP3 tracks, the bit rate should be at
least 128 kbit/s.
ț Surround sound does not function for
mono-signal sources.
ț In the event of poor radio reception quality,
e.g. inside a tunnel, you should switch off
LOGIC7
®
, as a dynamic switch from Stereo
to Mono could occur, resulting in temporary
sound distortion.
ț With some stereo recordings, the resulting
sound may deviate from conventional stereo
playback.
i
When you insert an audio CD or audio DVD,
it automatically becomes the active audio
source.