Filter
Top Products
187
Control systems
COMAND navigation system (entering a destination)
List of house numbers with input
characters
When this list appears, the input charac-
ters 4 are automatically activated.
1 Numbers entered by the user
2 Numbers automatically added by the
system
3 Top list entry based on the input data
up to that point
4 Input characters
5 Currently non-selectable numbers
6 Currently selected number
7 Currently selectable numbers
8 List of house numbers
While the numbers are being selected as
described below, the top list entry 3 al-
ways shows the house number which best
corresponds to the input data as it has
been entered up to that point.
At the same time, COMAND automatically
supplements numbers 1 entered by the
user with appropriate numbers 2.
̈ Selecting numbers: Slide omp or
rotate ymz.
̈ Confirming number selection:
Press n.
̈ Deleting individual numbers:
Select ) in the bottom line and
press n.
̈ Deleting an entire entry: Select ) in
the bottom line and press n until the
entire entry is deleted.
̈ Canceling an entry: Select “Back” in
the bottom line and press n.
or
̈ Press back button L in the center
console (
୴ page 86).
As soon as COMAND can clearly attribute
the numbers entered to a house number,
the input characters 4 disappear. You see
the list of house numbers without the input
characters. Here you can confirm the cur-
rent entry or make another selection.
During number entry, you can also manual-
ly switch to the list of house numbers with-
out input characters at any time.
̈ Switching manually to the list of
house numbers without input char-
acters: Slide qm.
or
̈ Select ? in the second line from the
bottom and press n.
i
In the list of input characters 4, you can
only select currently selectable characters.
Which characters are included depends on the
sequence in which you have entered your desti-
nation and the data version of the digital map.