Filter
Top Products
144
Control systems
COMAND telephone*
Placing a call to a call list entry or
COMAND phone book entry
̈ Call up a call list and select an entry
(
୴ page 140).
or
̈ Call up COMAND phone book and se-
lect an entry (
୴ page 147).
̈ Connecting a call: Press n.
Speed dialing
You can save telephone numbers in the
speed-dial preset locations on the mobile
phone and call up the speed-dial presets
(see mobile phone operating instructions).
You can also call up speed-dial numbers
using COMAND.
Calling up speed-dial presets using the
COMAND controller
̈ Switching screen to telephone
mode: Call up main telephone menu
(
୴ page 139).
̈ Entering number of a speed-dial pre-
set: Select all the digits in sequence.
̈ Deleting individual digits:
Select ) and briefly press n.
̈ Deleting entire number:
Select ) and press n until the
number is deleted.
̈ Connecting a call (speed-dial pre-
sets 1 -99): Select “S”.
or
̈ Connecting a call (speed-dial pre-
sets 100 - 999): Select “#” after the
digits Ǟ “S”.
In both cases, the telephone connects
the call to the saved telephone num-
ber. If the speed-dial memory contains
no telephone numbers, you will see a
corresponding message.
̈ Deleting message: Press n.
Calling up speed-dial numbers using the
telephone keypad
̈ Switching screen to telephone
mode: Call up main telephone menu
(
୴ page 139).
̈ Single-digit numbers: Press and hold
A - 9 buttons.
or
̈ Single- and two-digit numbers: Enter
number using the A - 9 buttons.
̈ Press s.
or
̈ Three-digit numbers: Enter number
using the A - 9 buttons.
̈ Press #, and then s.
In all three cases, COMAND connects
the call to the saved telephone num-
ber. If the speed-dial memory contains
no telephone numbers, you will see a
corresponding message.
i
By default, the mailbox number is preset in
the speed dial memory unless you have modified
it. For more information on the mailbox
(
୴ page 139).
i
Operation during call connection depends
on the speed-dial preset position called up.