Filter
Top Products
143
Control systems
COMAND telephone*
If you have accepted the call using the
Bluetooth
®
headset, the call will be con-
ducted via the headset.
Further operating functions can be found
in the “Functions during a single-call con-
nection” section (
୴ page 145).
You can also accept a call if the
COMAND display is showing a screen oth-
er than the telephone mode screen. After
accepting the call, you will see the caller’s
data in a window.
̈ Closing window: Slide qmr or omp
or press n.
Making an outgoing call
Entering the telephone number using
the COMAND controller
̈ Switching screen to telephone
mode: Call up main telephone menu
(
୴ page 139).
̈ Entering digits: Select desired digits
by rotating ymz or sliding omp and
press n.
̈ Deleting individual digits: Select )
and briefly press n.
̈ Deleting an entire telephone num-
ber: Select ) and press and hold n
until the telephone number is deleted.
̈ Connecting a call: Select “S”.
Entering a telephone number using the
telephone keypad
̈ Switching screen to telephone
mode: Call up main telephone menu
(
୴ page 139).
̈ Use telephone keypad to enter digits.
̈ Connecting a call: Press s.
Redial
̈ Switching screen to telephone
mode: Call up main telephone menu
(
୴ page 139).
̈ Use COMAND controller to select
“S”.
or
̈ Press s on the telephone keypad
(
୴ page 88).
The list of dialed numbers appears. The
most recently dialed number is at the
top.
̈ Select desired entry.
̈ Connecting a call: Press n.
i
If you place an outgoing call and receive a
busy signal, the telephone automatically starts
to redial as long as the provider and the mobile
phone support this function (see mobile phone
operating instructions).
While the call is connecting, you can also send
character strings (
୴ page 145).
i
A detailed description of how to enter digits
using the telephone keypad can be found on
(
୴ page 88).
i
If the list of dialed calls contains no entries,
the “S” menu item cannot be selected and the
s button on the telephone keypad does not
function.