Filter
Top Products
167
Control systems
COMAND navigation (introduction)
̈ Showing: Press n in the full-screen
map display.
Adjusting the map scale
̈ Rotate ymz until the desired map
scale is set.
1 Currently set map scale as number
2 Scale
3 Currently set map scale as a needle on
the scale
4 Previously set value before calling up
the scale
As soon as you rotate ymz, scale 2
appears. Rotating clockwise zooms in,
rotating counterclockwise zooms out.
Saving current vehicle position as des-
tination in last destinations list
̈ Showing menu system, if neces-
sary: Press n.
̈ Saving: Select “Position” Ǟ “Save Po-
sition”.
COMAND saves the current vehicle po-
sition as a destination in the last desti-
nations (
୴ page 223).
Moving the map
̈ Slide qmr, omp or wmx.
A crosshair appears on the map.
1 Crosshair
2 Details of the crosshair position
3 Map scale
i
It is only possible to adjust the map scale
with the menu system hidden (full-screen map
display).
i
It is only possible to move the map with the
menu system hidden.
i
Display 2 may be the name of a road, for
example, provided the digital map contains the
necessary data.
If no data is available, display 2 shows:
ț the coordinates of the crosshair if the
geo-coordinate display is switched on
(
୴ page 170) and the GPS signal is strong
enough
ț no display if the geo-coordinate display is
switched off (
୴ page 170)