Filter
Top Products
281
Control systems
Instrument cluster control system
If conditions have occurred causing
status messages to be recorded, the
number of messages appears in the
multifunction display: “2 Messages”.
̈ Press % or $ to select the mes-
sage.
̈ Press # to confirm.
Checking tire inflation pressure
For information about checking tire infla-
tion pressure (
୴ page 561).
Activating Run Flat Indicator
(Canada only)
For information about activating Run Flat
Indicator (
୴ page 565).
Calling up the maintenance service in-
dicator display
For information about calling up the main-
tenance service indicator display
(
୴ page 582).
Checking engine oil level (S 600 and
S65AMG)
For information about checking engine oil
level (
୴ page 543).
Settings menu
In the “Settings” menu, you can:
ț switch the daytime running lamps on or
off (USA only)
ț switch the additional speedometer on
or off
ț switch the radar sensors* on or off
(USA only)
Setting daytime running lamp mode
(USA only)
̈ Press ( or & to select the “Set-
tings” menu.
̈ Press % or $ to select the “Day-
time driving lamps” function.
̈ Press #.
̈ Press # again if you would like to
change the current status.
Depending on the previous status, the
daytime running lamps will be switched
on or off.
i
See the “Practical hints” section for mal-
function and warning messages (
୴ page 612).
i
If you turn the SmartKey in the starter
switch to position 0 and then back to position 2,
all messages will be deleted from the message
memory.
i
The menu overview can be found on
(
୴ page 266).
i
This function is not available in countries
where the daytime running lamp mode is manda-
tory and therefore in a constant mode.