Filter
Top Products
185
Control systems
COMAND navigation system (entering a destination)
Which of the following menu items are now
available may depend on the data version
of the digital map. The menu items which
are not available cannot be selected.
ț “Map”: using the map to enter a desti-
nation (
୴ page 193)
ț “POI”: entering a point of interest
(
୴ page 196)
ț “Save”: saving a destination in the des-
tination memory (
୴ page 217)
ț “Start”: starting the route calculation
(
୴ page 190)
̈ Continuing or completing destina-
tion entry: Select one of the menu
items mentioned above.
Entering a house number
How the house number is entered depends
on whether you have already entered just
the street or both the street and the town
or city (
୴ page 186).
With only the street entered previously
When COMAND can clearly allocate the
street to a town or city, the house number
appears without input characters. Select a
house number from the list (
୴ page 188).
When COMAND cannot clearly allocate the
street to a town or city, a house number
screen appears. You can now enter a
house number.
1 Numbers entered by the user
2 Input characters
3 Currently selected number
̈ Selecting numbers: Slide omp or
rotate ymz.
̈ Confirming number selection:
Press n.
̈ Deleting individual numbers:
Select ) in the bottom line and
press n.
̈ Deleting an entire entry: Select ) in
the bottom line and press n until the
entire entry is deleted.
i
In this case, using the map for destination
entry is based on the center seen in the address
input menu.
i
In this case, entering a point of interest is
based on the center seen in the address input
menu.
i
The house number can only be entered after
the street has been entered.
You can only enter those house numbers which
are saved on the digital map. The digital map
does not contain all house numbers for all
streets.
୴୴