Filter
Top Products
LX 7007 pro IGC V1.0 Apr.2005
Page 42
During an active task leg, the time will remain blank as it is the TP confirmation time and is never shown until the TP
is confirmed. The completed leg display shows time turn made, the time spent completing the leg (duration), average
speed on leg and % of time spent climbing. The last shown screen always shows the task statistics from the start to the
current position.
2.2.6.2 Statistics after flight
2.2.6.2.1 LOGBOOK
These statistics are available after flight. The logbook shows the flights by date with take off and landing time. The
logbook entry will appear approximately 3 minutes after landing and is the signal that the flight is finished and that the
unit can be switched off.
2.2.6.2.2 Statistics after flight
The LX 7007 PRO IGC provides post flight statistics and analysis. To start the procedure, select the flight from
LOGBOOK and press ENTER.
The flown distance will appear if the unit has any task information ( either a programmed TSK or a simple task - see
para 3.4.4.7). If no task information is available, then the TASK NOT SPECIFIED message will appear. Speed is
average speed on task.
After pressing ENTER the pilot is able to recall the route flown and barogram.
During leg Completed leg
Time of confirmation Average speed on leg