B KLN 94
Rev. 4, Jan/2003 10599I04.CDL Page 1-10
It is necessary to swap cards to update the cartography data. Updating the navigation database
will not compromise the cartography database.
Laptop computers used to load the database require the following:
1. IBM compatibility
2. An available Com 1,2,3, or Com 4 serial port
NOTE
The PC must be fully IBM compatible and must have a 3.5" high
density diskette drive, If the database is loaded from a diskette sent
from Honeywell. For more information, contact Honeywell Product
Services by telephoning (913) 712-0600.
1.6.2 Annunciators and Switch/Annunciators
(Refer to I.B. 363 for additional information pertaining to switch/annunciators for GPS systems)
The devices shown below are Eaton 582/584 series switch/annunciators and are representative
of those used in our original certification. They were chosen because of their excellent sunlight
readable characteristics and meet or exceed the requirements of Advisory Circular 20-138.
These are high quality devices and we encourage their use. However, there are other
comparable devices on the market that may be substituted at the installer’s/customer’s choice.
These switch/annunciators are available through Honeywell Service Stock or direct from our
supplier, LCOMP Inc. It is advantageous to order direct from LCOMP, if possible, in order to avoid
additional price mark-ups. On international orders, it may be necessary to order through
Honeywell as LCOMP, at the time of this publication, is not prepared to handle international
orders. The address and telephone numbers for LCOMP are listed as follows:
LCOMP Aerospace Controls (913) 438-4848 Telephone
c/o Carlton-Bates Co. (800) 786-0617 Toll Free
9214 Bond St. (913) 438-4839 Fax
Overland Park, KS 66214
NOTE
The switch/annunciators listed below in many cases show two
numbers. The part numbers that are shown in parentheses are
devices previously called out and may be used until supply is
depleted. The 031-00785-XXXX are the preferred
Switch/Annunciator assemblies.