Filter
Top Products
68
Appendix C
The StreetPilot may be connected to a PC, beacon receiver, marine autopilot or other compatible
device using the supplied PC Interface Cable with RS 232 Serial Port Connector (P/N 010-10141-00)
The StreetPilot may be connected to a vehicle’s electrical system (10-32 VDC) and a PC, beacon
receiver, marine autopilot, or other compatible device using the optional PC Interface Cable with
Cigarette Lighter Adapter (P/N 010-10165-00).
The StreetPilot may be connected to a second StreetPilot using the optional Data Transfer Cable
(P/N 010-10142-00) in order to transfer data from unit to unit.
The StreetPilot may be hard-wired to the vehicle’s electrical system (10-32 VDC) and a PC, beacon
receiver, marine autopilot or other compatible device using the Power/Data Cable with bare wire leads
(P/N 010-10082-00).
WARNING: the terms of the GARMIN Warranty require that the Power/Data Cable with bare wire
leads be installed by experienced installers at a qualified installation facility, (i.e. electrical accessory
installation center, auto, or marine dealer service center). The end-user should not attempt installation
without proper knowledge of automotive or marine electrical systems and skill in the use of special
tools or hardware required for installation.
Consult the wiring diagrams at the side and bottom of the page for proper connections. (The male
connector on the back of the StreetPilot and wiring leads are illustrated to the left, wiring lead color
coding is illustrated below.)
Power and Data Connections from Back of Unit
(-) Ground
Data IN
(+) Power
Data OUT
Power and Data Port Cover
To remove the attached antenna for connection to a
remote antenna: rotate to a 45
o
angle and gently pull
away from the unit. The antenna port accepts a
standard BNC connector.
Wiring/Interfaces
Power/Data Cable Assembly: P/N 010-10082-00