Filter
Top Products
The GPS III Pilot can be mounted on any flat surface using the two Velcro™ strips
provided in the standard package, or you can use the supplied mounting bracket.
To mount the GPS III Pilot using the Velcro strips:
1. Select a location for the unit that provides a clear and unobstructed
view of the sky for the GPS antenna, but will not obstruct your field
of view while flying.
2. Make sure the surface to which you’re adhering the Velcro is clean
and dry. Remove the paper liners from both Velcro pieces.
3. Place the adhesive side of the rough piece of Velcro on the desired
mounting surface, and press into place.
4. Place the adhesive side of the smooth piece of Velcro on the bottom
of the unit (between the rubber anti-skid bumps), and press into place.
5. Mount the unit, placing one piece of Velcro on top of the other.
To mount the GPS III Pilot using the bracket:
1. Select a location for the unit that provides a clear and unobstructed
view of the sky for the GPS antenna, but will not obstruct your field
of view while flying.
2. Make sure the surface to which you’re adhering the Velcro is clean
and dry. Remove the paper liners from both Velcro pieces.
3. Place the adhesive side of the rough piece of Velcro on the desired
mounting surface, and press into place.
88
APPENDIX A
Mounting Instructions
GPS III Pilot B2 4/1/99 2:02 PM Page 88